W.T.K some stuff on b13 engine

evolve · Posted: Tue Jul 07, 2009 9:10 pm Post subject: W.T.K some stuff on b13 engine

how will u kno wen a b13 engine is back pressuring & symtoms u wud have???

minipresident · Posted: Wed Jul 08, 2009 1:11 pm Post subject:

Smoke/fumes cud bee seen when the oil cap is removed, while the engine is running. the same cud also be seen through the vent lines on the tappet pan cover.

evolve · Posted: Wed Jul 08, 2009 5:00 pm Post subject:

ok,but i doh see no smoke/fumes,d only thing is wen i mash on d kick down & i open the air filter,which is connected to the top of the engine i is see oil resting on the side,nun much really,is this normal & sum how i feel i losing power!!!jus saying?

minipresident · Posted: Thu Jul 09, 2009 4:56 pm Post subject:

could be early signs of back pressure. would not worry too much.

evolve · Posted: Thu Jul 09, 2009 5:04 pm Post subject:

yeah,i feel is an early signs of back pressure,but wen it get bad i go hav to change rings,i think! anything else i wud have too change.dat hav anything to cause the oil to get black quick!

minipresident · Posted: Fri Jul 10, 2009 7:33 am Post subject:

Oil getting black too quick may be caused by over fueling. see if u burning black at the tail pipe. i suggest u get a timing light put on the engine to set the timing spot on. it should help with some of your troubles.

evolve · Posted: Fri Jul 10, 2009 8:42 pm Post subject:

ok den,yea the tail pipe burning rel black,i go see if i cud get a timing light put on,will it be too much trouble to installed.thanks for the advice!!!

X_Factor · Posted: Fri Jul 10, 2009 9:13 pm Post subject:

what i was told how to check back pressure, slacken the oil fil cap right out, and allow it to just rest on the hole...it should just rattle there while the engine is on idle, if it jumps off or the pressure pushes it off...u got back pressure...

correct me if im wrong tho...

evolve · Posted: Sun Jul 12, 2009 1:33 am Post subject:

ok den,i will have a look at this,wat about if i do compression test!!!!!!!!!in that will tell if it back pressure.....