obd0 in an Ek3?

Achmed · Joined: 06 Feb 2008 Tech posts: 0 My 2NRide:

(this may have been asked on this forum at some point but just bear with me here fellas ...)

will an OBD-0 ECU work in an EK3 for a B16A manual install?

i know it's one of the older ECU's but i've read that it's JDM and rated A1.

What am i likely to sacrifice with trying to run this in an EK frame, i.e., panels, electronics and ofcourse, engine performance?

Also, is there a speed cut on these?

any info appreciated.

red_dragon · Street 2NR Joined: 08 Apr 2004 Tech posts: 84 My 2NRide:

^ that is because then only cared about power them

for your to use that u need a obd0 harness,ecu,distributor

there are no obd2 to obd0 conversion harness i know of

why not just chip an obd1 ecu and get a conversion harness Confused

kes_vtec · Posted: Thu Sep 25, 2008 7:09 am Post subject:

obd1 is ur best bet, with the least work

Achmed · Joined: 06 Feb 2008 Tech posts: 0 My 2NRide:

fellas...i'm getting an OBD2 brain to replace the OBD0 on the engine that i'm getting?

is the OBD2 the right brain for my EK3?

kes_vtec i know u said that the OBD1 was ideal but i just thought i'd ask.

again, it's a d-series auto to b-series manual swap.
just lookin for a hassle free and clean install.

De Dragon · Posted: Thu Oct 09, 2008 7:59 pm Post subject: