FS:Amplifiers & Chargers From Banda Audio Parts (Pics)

TheWiseOne · Last edited by TheWiseOne on Sun Oct 11, 2009 6:54 pm; edited 4 times in total

Introducing Banda Audioparts.

VIKING

-Output Power:

-10,000Wrms @ 1ohm / 12.6 VDC
-5500Wrms @ 2ohms / 12.6 VDC
-12000Wrms @ 1ohm / 14.4 VDC
-Power to the nearest full power @ 12.6 VDC: 950A (music signal)

• Class of operation: Class D bridge
• Frequency response: 30Hz to 6000Hz
• Subsonic filter at 30Hz (36dB/oitava)
• Total harmonic distortion (THD): less than 0.3%
• Signal to noise (S / N): better than 82.4 dB
• Input Sensitivity: 0.2 to 4Vrms
• Input signal in differential mode
• Minimum impedance: 1ohm
• Efficiency of the output stage: 85% (20 ° C)
• Power Cables: 4 x 50mm (1/0AWG) or 8 x 21mm (4AWG)
• Fire protection: reverse polarity on power, short-circuit,
Low voltage power (below 9.6 VDC) and high voltage power
(above 18Vcc)
• Control system with dedicated software: The amplifier is monitored
constantly
DSP fearing for assessing working conditions, such as voltage
food and if there is short-circuit.
• Dimensions:26.97 " / 2.99 " / 11.22"
• Weight: 17kg (37.48 lb)

VX3ND

-Output Power:

-3500Wrms @ 2ohms / 12.6 VDC
-2100Wrms @ 4ohms / 12.6 VDC
-1200Wrms @ 8ohms / 12.6 VDC
Consumption approximate the full @ 12.6 VDC power: 325A (music signal)

• Class of operation: Class D bridge
• Frequency response: 30Hz to 6kHz
• Butterworth lowpass : 40Hz to 6kHz
• Subsonic filter at 30Hz (36dB/oitava)
• Total harmonic distortion (THD): less than 0.3%
• Signal to noise (S / N): better than 82.4 dB
• Input Sensitivity: 0.2 to 4Vrms
• Input signal in differential mode
• Minimum impedance: 2ohms
• Low RF input power
• Chassis splitter for better thermal efficiency
• Efficiency of the output stage: 85% (20 ° C)
• Power Cables: 50mm (1/0AWG) or two 21mm (4AWG) in parallel
• Fire protection: reverse polarity on power, short-circuit
voltage and low voltage (below 9.6 Vdc)
• Control system with dedicated software: The amplifier is monitored
microprocessor constantly assessing working conditions, such as
voltage and if there is short-circuit.
• Dimensions: comp. 471mm (18.5 ") / alt. 68mm (2.68") / larg.285mm (11.22 ")
• Weight: 11kg (24.3 lb)

VXICE

-Output Power:

- Configuration 1 channel:
- 2.500Wrms @ 2ohms / 12.6 VDC
- 1.500Wrms @ 4ohms / 12.6 VDC
- 860Wrms @ 8ohms / 12.6 VDC
- Minimum impedance output: 2ohms
- Current consumption at full power: 220A (music signal)

Class of operation: Class D bridge.
- Crossover Active Butterworth Low Pass variable from 40Hz to 8000Hz (12dB/octave)
- Frequency response 30Hz to 8000Hz
- Subsonic filter variable 30 to 120Hz
- Clipping Indicator
- THD less than 0.33%
- Signal to Noise Ratio> 74.3 dB
- Input Sensitivity 0.1 to 4Volts
- Input impedance 150kohms
- Gain Control
- Input signal in differential mode
- Terminals and power outputs (triton)
- Protection of terminals ABS anti-flame
- Circuit check-out/check-in
- Source opposing position to the making and output.
- Low consumption at rest (1.9 A)

- Dimensions:
Comp. 308mm / Height 76mm / Width. 283mm
Weight: 5.5 kg

VXLOLLA

-Output Power:

- 2 channels (600wrms 2ohms / 12.6 Vdc) or
- 1 channel (1200Wrms 4ohms / 12.6 VDC)
- Current consumption at full power: 100A (music signal)

- Class of operation: Class D
- Crossover active card
- Linkwitz-Riley 12dB/octave:
- Low Pass 30Hz to 80Hz
- High Pass 80Hz to 20000Hz
- Flat 30hz to 20000hz
- Frequency response 30Hz to 20kHz-3dB
- Subsonic filter (36dB/oitava)
- THD less than 0.047%
- Signal to Noise Ratio> 83dB
- Input Sensitivity 0.1 to 4Volts
- Input impedance 150kohms
- Key MONO / STEREO
- Control of individual gain
- Input signal in differential mode
- Terminals and power outputs (triton)
- Protection of terminals ABS anti-flame
- Circuit check-out/check-in
- Source opposing position to the pre and output
- Low consumption at rest (1.9 A)
- Dimensions:
Comp. 308mm / Height 76mm / Width. 283mm
Weight: 5.5 Kg

VXPERT

-Output Power:

VXPERT 1ohm
• Configurations:
- 2 channels (600Wrms 0.5ohm/12.6Vdc) or
- 1 channel (1200Wrms 1ohm/12.6Vdc)

VXPERT 2ohms
• Configurations:
- 2 channels (600Wrms 1ohm/12.6Vdc) or
- 1 channel (1200Wrms 2ohms/12.6Vdc)

• Active Crossover for card
• Linkwitz-Riley 12dB/oitava:
- Low Pass 30Hz - 80Hz
- High Pass 80Hz - 45000Hz
- Flat 30hz - 4500hz
• Frequency response 30Hz 45kHz -3dB
• Subsônico filter ( 36dB/oitava)
• THD less than 0.017%
• Signal to Noise Ratio> 101dB
• Input Sensitivity 0.1 to 4Volts
• Input Impedance 150kohms
• Key MONO/STEREO
• Control of individual gain
• Input signal in differential mode
• Terminals and power outputs (triton)
• Protection of terminals in ABS anti-flame
• Circuit check-out/check-in
• Source opposing position to the pre and output
• Low consumption in rest (1,9A)
• Dimensions: -VXPERT 1ohm and 2ohms Comp. 441mm(17.36")/Alt. 76mm(2.99")/Larg. 283mm(18.08") Weight: 8.2kg

Click for full-size.

VX 9.8

-Output Power:

Configurations:
- 4 channels (300Wrms 1ohm/12.6Vdc) or
- 3 channels (2 x 300Wrms 1ohm 1 x 600Wrms 2ohms/12.6Vdc) or
- 2 channels (600Wrms 2ohms/12.6Vdc)

• Active Crossover for card
• Linkwitz-Riley 12dB/oitava:
- Low Pass 30Hz - 80Hz
- High Pass 80Hz -45000Hz
- Flat 30hz - 4500hz
• Frequency response 30Hz 45kHz -3dB
• Subsônico filter ( 36dB/oitava)
• THD less than 0.017%
• Signal to Noise Ratio> 101dB
• Input Sensitivity 0.1 to 4Volts
• Input Impedance 150kohms
• Key MONO/STEREO
• Control of individual gain
• Input signal in differential mode
• Terminals and power outputs (triton)
• Protection of terminals in ABS anti-flame
• Circuit check-out/check-in
• Source opposing position to the pre and output
• Low consumption in rest (1,9A)
• Dimensions: -VX9.8 comp. 441mm(17.36")/Alt. 76mm(2.99")/Larg. 283mm(18.08") Weight: 8.2kg

VX 5.0

-Output Power:

Configurations:
- 5channel (4 x 75Wrms 4ohms 1 x 300Wrms 4ohms/12.6Vdc)
- minimum Impedance / channel: 4ohms

• Linkwitz-Riley 12dB/oitava:
- Low Pass 80Hz mono
- High Pass 80Hz (front and rear)
• Frequency response 30Hz 45kHz -3dB
• Subsônico filter ( 36dB/oitava)
• THD less than 0.017%
• Signal to Noise Ratio> 101dB
• Input Sensitivity 0.1 to 4Volts
• Input Impedance 150kohms
• Key MONO/STEREO
• Control of individual gain
• Input signal in differential mode
• Terminals and power outputs (triton)
• Protection of terminals in ABS anti-flame
• Circuit check-out/check-in
• Source opposing position to the pre and output
• Low consumption in rest (1,9A)
• Dimensions: Comp. 308mm(12.13")/Alt. 76mm(2.99")/Larg. 283mm(11.14") Weight: 5,5kg

VX 4.8

- Output Power:

Configurations:
- 4 channels (150Wrms 2ohms/12.6Vdc) or
- 3 channels (2 x 150Wrms 2ohms 1 x 300Wrms 4ohms/12.6Vdc) or
- 2 channels (300Wrms 4ohms/12.6Vdc)

• Active Crossover for card
• Linkwitz-Riley 12dB/oitava:
- Low Pass 30Hz - 80Hz
- High Pass 80Hz - 45000Hz
- flat 30h - 4500hx
• Frequency response 30Hz 45kHz -3dB
• Subsônico filter ( 36dB/oitava)
• THD less than 0.017%
• Signal to Noise Ratio> 101dB
• Input Sensitivity 0.1 to 4Volts
• Input Impedance 150kohms
• Key MONO/STEREO
• Control of individual gain
• Input signal in differential mode
• Terminals and power outputs (triton)
• Protection of terminals in ABS anti-flame
• Circuit check-out/check-in
• Source opposing position to the pre and output
• Low consumption in rest (1,9A)
• Dimensions: Comp. 308mm(12.13")/Alt. 76mm(2.99")/Larg. 283mm(11.14") Weight: 5,5kg

VX Vento

- Output Power:

Configurations:
- 2 channels (300Wrms 2ohms/12.6Vdc)
- 1 channel (600Wrms 4ohms/12.6Vdc)

• Active Crossover for card
• Linkwitz-Riley 12dB/oitava:
- Low Pass 30Hz - 80Hz
- High Pass 80Hz - 45000Hz
- flat 30hz - 4500hz
• Frequency response 30Hz 45kHz -3dB
• Subsônico filter ( 36dB/oitava)
• THD less than 0.017%
• Signal to Noise Ratio> 101dB
• Input Sensitivity 0.1 to 4Volts
• Input Impedance 150kohms
• Key MONO/STEREO
• Control of individual gain
• Input signal in differential mode
• Terminals and power outputs (triton)
• Protection of terminals in ABS anti-flame
• Circuit check-out/check-in
• Source opposing position to the pre and output
• Low consumption in rest (1,9A)
• Dimensions: Comp. 308mm(12.13")/Alt. 76mm(2.99")/Larg. 283mm(11.14") Weight: 5,5kg

Vento D

- Output power

· 1 channel (800 Wrms / 4 ohms)

· System Exclusive Crossflex;
· Can be used in order Flat, High or Low, according to the RCA input used;
· Crossover Crossflex;
· Linkwitz - Riley 12 dB / octave
· Low-Pass, 30 Hz to 80 Hz
· High-Pass: 80Hz to 20 kHz
· Full: 30 Hz to 20 kHz
· Frequency response: 30 Hz to 20 kHz;
· Subsonic filter;
· THD: less than 0.09%;
· Signal to Noise Ratio> 86.8 dB;
· Current consumption at full power: 70 A (music signal);

Dimensions
Compr. 200mm(7.87") / Height 60mm(2.36") / Width. 200mm(7.87")

VX Energia

Description

Digital Converters AC / DC 220 VAC / 12.6 VDC / 150A.
Technology step-down quad. PWM
His control is to have microprocessor speed correction and the ability to anticipate events outside the control (short type, low voltage or overload)
Semiconductor materials for high performance.

Specifications:
Performance: 12.6 VDC to 150A (maximum variation of 5%).
Time correction: 20μs microseconds.
Reaction to events illegal: 50μs microseconds.
Use: feed the sound of your car right off, without ultilizar the battery.
Dimensions: 28.3 x 7.6 x 30.8 (HxWxD)
Weight 7.5 kg.

All Forum memebers interested in Banda amplifiers can conatct me via pm or call me at 362-2814 for prices and inquiries. Very Happy